Prekių paieška
- Lėktuvai
- Automobiliai
- Sraigtasparniai
- Multikopteriai
- Laivai
- Tankai
- Aitvarai
- Robotai
- Valdymas/ Stabilizavimas
- Servo mechanizmai
- Elektriniai varikliai
- Greičio reguliatoriai
- Akumuliatoriai/ Pakrovėjai
- Fpv/ Foto/ Video/ Osd
- Vidaus degimo varikliai
- Įrankiai/ Priedai
- Medžiagos
- Dalys lėktuvams
- Dalys automodeliams
- Dalys sraigtasparniams
- Naudotos prekės
Nuorodos
75:1 Metal Gearmotor 25Dx54L mm HP
This cylindrical, 2.13" x 0.98" x 0.98" gearmotor uses a motor with extra-strong magnets and a 75:1 metal gearbox to deliver a lot of power in a relatively small package. These units have a 0.315"-long, 4 mm-diameter D-shaped output shaft. This is the same motor used on the Dagu Wild Thumper 6WD all-terrain chassis 75:1. We also carry a lower-power version of this gearmotor and a version with an encoder.
Key specs at 6 V: 130 RPM and 450 mA free-run, 130 oz-in (9.4 kg-cm) and 6 A stall.
These motors are intended for use at 6 V. In general, these kinds of motors can run at voltages above and below this nominal voltage, so they should comfortably operate in the 3 – 9 V range, though they can begin rotating at voltages as low as 1 V. Higher voltages could start negatively affecting the life of the motor.
Key specs at 6 V: 130 RPM and 450 mA free-run, 130 oz-in (9.4 kg-cm) and 6 A stall.
These motors are intended for use at 6 V. In general, these kinds of motors can run at voltages above and below this nominal voltage, so they should comfortably operate in the 3 – 9 V range, though they can begin rotating at voltages as low as 1 V. Higher voltages could start negatively affecting the life of the motor.
