Prekių paieška
« Ankstesnė prekė
Prekės informacija

Sky Runner sklandytuvas 2.4GHz RTF

A-NE207001A/EUR
Sky Runner sklandytuvas 2.4GHz RTF
[+] Padidinti

8 Reitingai
319,00 Lt
Turime Lietuvoje

Sky Runner sklandytuvas 2.4GHz RTF

Specialiai sukurtas pradedantiem RC pilotams. Su šiuo modeliu galėsite gerai išlavinti modelio valdymo įgudžius nesibaimindami tuoj pat sudaužyti modelį. Dėka spirokliuojačios važiuoklės ir ypatingai atsparios smūgiams konstrukcijos šis modelis atlaikys net ir pačius skaudžiausius kriašus. 100% paruoštas skrydžiui! Absoliučiai viskas ko jums reikia rasite dėžėje.

Pagrindinės savybės:

Pagamintas iš smugiams aptsparaus EPP
Valdomas 3 kanalais - ruderis, aukščio vairas ir variklis
Valdymas lengvai perdaromas į mode 1 arba mode 2
Lipo akumuliatorius
Reguliuojamos traukės

Specifikacija:

TX: NE-024G
RX: NE R/C 772B
Wingspan: 703mm
Overall length: 514mm
Flying weight: 85g
Motor: N20
Height: 156mm
Battery: 7.4V 250mAh Lipo

Komplektacija:

Pilnai paruoštas skrydžiui modelis su elektronika
Lipo įkroviklis
Maitinimo blokas
Lipo akumuliatorius 7.4V 250mAh
Siųstuvas 2.4GHz
4x Alkaline baterijos siųstuvui
atsarginis propeleris

Binding instructions primary (beginner) mode:

Firstly, you must have batteries in the model with sufficient charge and a charged battery/battery pack ready for the model.

1. With the model's battery/battery pack disconnected, press and hold down the throttle/rudder control stick so that it clicks and switch 'ON' the transmitter. Release the throttle/rudder stick.

2. The transmitter will start to emit an audible beep and three horizontal dashes will start to climb the screen of the LCD display.

3. Ensure the throttle/rudder stick is as low as it can go and connect the battery/battery pack in the model.

4. After a few seconds, the transmitter and model will automatically 'bind' and the transmitter's LCD screen will revert back to its normal display. The audible beep will also cease.

Binding instructions advanced (experienced) mode:

Firstly, you must have batteries in the model with sufficient charge and a charged battery/battery pack ready for the model.

1. With the model's battery/battery pack disconnected, switch 'ON' the transmitter.

2. Simultaneously, press down and hold both sticks so that they click (like a game controller) - you will hear a tone and the normal LCD display will change to 3 horizontal dashes.

3. Next, release the sticks and connect the battery/battery pack in the model.

4. Finally, wiggle the transmitter's stickers (no need to press down on them) for around 6~7 seconds and the LCD display should revert to normal, indicating that control has been re-established and binding is complete.

[?] Turite klausimų apie prekę?
Atsiliepimai apie prekę
« Ankstesnė prekė